Settings on Coordinators

To configure a coordinator to tunnel (encrypt) the traffic between local area networks:

1. Click the Tunneling button in the Settings window.

   

   The Tunnelling IP addresses ranges dialog box appears:

   

2. Click the Add button. The IP address dialog box appears:

   

3. Type the IP address range or single IP addresses which will be tunnelled by the coordinator.
4. Click OK.

   

5. Repeat this process to add as many IP addresses as your license allows.

   Note: The number of IP addresses can exceed the number of possible simultaneous tunnels defined by your license, however, only the number of clients defined in the license will be tunnelled; the rest will be blocked.

6. Click the Apply to save your settings.
7. To specify the tunneled addresses for other coordinators in the Private Network you want to use for tunneling:
   1. Either:
      • Double-click the coordinator in the Private Network, or
      • Right-click the coordinator name and select Access Rules > Open from the pop-up menu.

        The Access rule window will appear.

   2. Click the Tunnel tab.

      

   3. Tick the Use IP addresses for tunneling check box.
   4. Click the Add button. The IP address dialog box appears:

      

   5. Type the IP addresses for tunneling by this coordinator and click OK.
   6. To avoid IP address conflicts, click the Use virtual IP addresses check box.
8. Repeat this procedure for all coordinators from the Private Network you want to use for tunneling.

Back to top

© 2007 Infotecs